|
Post by greenZJ on Jun 22, 2005 20:39:26 GMT -3
hey everyone i got my OME shocks, N39L for the front and i actually got N66L that are for the rear of a TJ, but i changed my mind and i am going to use the N66L for the rear , how do i get the bar pin out, it doesnt really slide out.... i was hoping they wouldnt have to be pressed out , any ideas how to get them out with our pressing them.
I guess if i have to get them pressed where can i get hat done..... I live in woburn so i am pretty accessible to anyplace.
Matt
|
|
|
Post by dsgray16 on Jun 22, 2005 20:40:45 GMT -3
just use a C-clamp a BFH on them
|
|
xjma
New Member
Got Rocks?
Posts: 28
|
Post by xjma on Jun 22, 2005 20:54:59 GMT -3
put some dish soap on them and then push them out by pressing it down on a hard surface.
|
|
|
Post by greenZJ on Jun 22, 2005 21:11:40 GMT -3
ok i feel like an idiot ...... i tried the c clamp it work ok........anyways im doing this all on my work bench which happens to have a vise..... i guess its good for something.. it did it in like 5 seconds.........thanks for the idea Matt
|
|
|
Post by JeepFan555 on Jun 23, 2005 10:28:40 GMT -3
I had the same problem when I was installing my lift, I put the wrong bushings in the end and didn't realize until I had the pin in.
|
|